diff options
Diffstat (limited to 'doc/book')
| -rw-r--r-- | doc/book/reference-manual/configuration.md | 15 |
1 files changed, 13 insertions, 2 deletions
diff --git a/doc/book/reference-manual/configuration.md b/doc/book/reference-manual/configuration.md index 38062bab..348a352a 100644 --- a/doc/book/reference-manual/configuration.md +++ b/doc/book/reference-manual/configuration.md @@ -42,6 +42,17 @@ client_cert = "/etc/consul/consul-client.crt" client_key = "/etc/consul/consul-key.crt" tls_skip_verify = false +[consul_service_discovery] +consul_http_addr = "https://127.0.0.1:8501" +consul_http_token = "abcdef-01234-56789" +service_name = "garage" +ca_cert = "/etc/consul/consul-ca.crt" +tls_skip_verify = false +# tags to add to the published service +tags = [ "dns-enabled" ] +# additional service meta to send along registration +meta = { dns-acl = "allow trusted" } + [kubernetes_discovery] namespace = "garage" service_name = "garage-daemon" @@ -201,7 +212,7 @@ Garage supports the following replication modes: that should probably never be used. Note that in modes `2` and `3`, -if at least the same number of zones are available, an arbitrary number of failures in +if at least the same number of zones are available, an arbitrary number of failures in any given zone is tolerated as copies of data will be spread over several zones. **Make sure `replication_mode` is the same in the configuration files of all nodes. @@ -245,7 +256,7 @@ Values between `1` (faster compression) and `19` (smaller file) are standard com levels for zstd. From `20` to `22`, compression levels are referred as "ultra" and must be used with extra care as it will use lot of memory. A value of `0` will let zstd choose a default value (currently `3`). Finally, zstd has also compression designed to be faster -than default compression levels, they range from `-1` (smaller file) to `-99` (faster +than default compression levels, they range from `-1` (smaller file) to `-99` (faster compression). If you do not specify a `compression_level` entry, Garage will set it to `1` for you. With |